This website uses cookies to ensure that we give you the best experience on our website.
By continuing to browse the site you are agreeing to our use of cookies. To find out more click here

Weber Saint-Gobain - Official website of the company

weberfloor 4716

weberfloor 4716
weberfloor 4716

Product Benefits

weberfloor 4716 is designed for priming (pre-treating) all substrates prior to application of weberfloor products. weberfloor 4716 should be diluted with clean water. weberfloor 4716 is designed for use on a wide range of substrates: ● In-situ and pre-cast concrete ● Lightweight concrete ● Ceramics ● Stone ● Timber ● Steel plate

Water-borne primer dispersion for use with all cementitious and hemi-hydrate floor screeds

Product Features

About this Product

weberfloor 4716 primer is a styrene acrylate dispersion which can be diluted with water and is intended for use with Weber's flooring products.

weberfloor 4716 does not contain ammonia. It offers good alkali resistance and adhesion properties in both wet and dry environments.

Features and Benefits

▲ Regulates the porosity of the substrate ▲ Improves the adhesion of flooring products ▲ Reduces the formation of pinholes in the levelling layer ▲ Can be spray applied for use on large areas

Technical Services

Weber's Customer Services Department has a team of experienced advisors available to provide on-site advice both at the specification stage and during application. Detailed specifications can be provided for specific projects or more general works. Site visits and on-site demonstrations can be arranged on request.

Technical helpline
Tel: (01525) 722110
Fax: (01525) 718988

Sales Contact

Weber products are distributed throughout the UK through selected stockists and distributors. For UK sales enquiries and overseas projects, contact Weber's Sales office.

Sales office
Tel: 08703 330070 (Press 1 for Sales)                                                      Fax: (01525) 718988


Send or download the documents

You can either send the documents to an email address, or download it

Preparation & Application


The substrate should be clean and free from dust, cement, grease or other impurities which might prevent weberfloor 4716 from adhering to the substrate.

For correct film formation the substrate temperature should not fall below +6°C. For best results the temperature of the work area should be between +10 and +15°C.


weberfloor 4716 should be diluted with clean water according to the ratios given in the Technical Data.

To obtain the correct mixed ratio, always measure the water into a plastic container and add the concentrated primer.

Addition of water to the concentrated primer may result in foaming. The dilution of water and primer is easily mixed with a wooden stick.


The primer solution should be spread evenly over the prepared floor surface using a soft brush or spray, avoiding ponding, and allow to become touch dry (3 - 5 hours under normal conditions.)

After application and while the primer is still fresh, it should be lightly brushed to ensure a complete uniform film has been applied.

Drying time

3 - 5 hours (under normal conditions). Overnight (under poor conditions).


Once dried, weberfloor 4716 is difficult to remove so care should be taken to clean tools quickly before the primer dries.

Packaging, Health & Safety


weberfloor 4716 is supplied in 25 litre and 5 litre plastic bottles.

Storage and Shelf Life

12 months in concentrated form in dry, frost free conditions. If weberfloor 4716 has been allowed to freeze it should not be used.

Health and Safety

Essentially non-hazardous. Not harmful under normal use. After contact with skin, wash immediately with plenty of water. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. Keep out of the reach of children.

For further information, please request the Material Safety Data Sheet for this product.