About this product
weber.tene SG is a polymer-based decorative coating with a fine aggregate finish.
Features and Benefits
- Natural marble aggregates provide long lasting, durable finish
- Factory batched for consistency
- Available in a range of colours
- Practical benefits of ease of application, speed, economy and long shelf-life
- Technical support from a Quality Assured company
- Established track record in varying climatic conditions
Colours
weber.tene SG is available in a range of 12 colours. Specifiers should consult the Colour Chart on page 30 of the specifiers' handbook weber render solutions and, whenever possible, obtain samples prior to specification.
Constraints
Do not apply:
On horizontal or sloping surfaces exposed to wet conditions
Below DPC level
On hot, damp or frozen/thawing surfaces
During very humid weather conditions or if rain is forecast
During extreme hot weather or when exposed to strong winds
The quality of application of this material depends on suitable operative skills and product familiarity.
Restrictions on weather conditions during application and curing must be respected.
Sound trade practices and printed instructions must be followed.
Good access and appropriate protection must be provided.
Preparation
Rendered substrates must be flat, clean, sound, dry and free of dust or other contamination.
On porous/friable surfaces apply one coat of weber SL410. Allow to dry (between 4 - 6 hours) then prime with two coats of weber PR330. Allow to dry - 24 hours.
Application
Plan and set out work bays approximately 20 m2 with adhesive tape in order to disguise any potential day joints.
Apply weber.tene SG using a stainless steel trowel.
After a few minutes, smooth the surface to an even level using a stainless steel float.
The finished thickness is governed by the aggregate size i.e. approximately 3 mm.
When applying weber.tene SG on external angles, always start work from the edge.
Remove adhesive tape before the coating hardens.
Allow to dry out; the white polymer will be noticeable on the surface but will disappear as the coating dries out.
Apply in temperature (ambient and surface) between 5°C and 30°C.
Spillages stain and are difficult to remove so:
- protect vulnerable areas thoroughly
- wear protective clothing
Clean tools after use with water.
Good practice
Do not apply:
- If frost is forecast within 24 hours of use
- In damp/wet conditions
- In temperatures below 5°C or above 30°C
- On elevations in direct sunlight or where the substrate is hot
Storage and Shelf life
When stored airtight in a dry place at temperatures above 5°C and protected from frost, shelf life is 12 months from date of manufacture.
Do not over-stack.
Health and Safety
weber.tene SG and weber PR330 Essentially not hazardous. Not harmful during normal use. After contact with skin, wash immediately with plenty of water. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. Keep out of the reach of children.
weber SL410 Contains low boiling point treated naptha (white spirit). Flammable. Harmful: may cause lung damage if swallowed. Do not breathe vapour. Avoid contact with skin and eyes. Wear suitable protective clothing, gloves and eye / face protection. If swallowed, do not induce vomiting: seek medical advice immediately and show container or label.
For further information, please request the Material Safety Data Sheets for these products.
Technical services
weber's Customer Services Department has a team of experienced advisors available to provide on-site advice both at the specification stage and during application. Detailed specifications can be provided for specific projects or more general works. Site visits and on-site demonstrations can be arranged on request.
Technical helpline
Tel: (01525) 722110
Fax: (01525) 718988
Sales Contact
Sales, England and Wales
Tel: (01525) 722100
Fax: (01525) 718988
Sales, Scotland
Tel: (0141) 445 0121
Fax: (0141) 445 0122
Sales, Ireland
Tel: (028) 9335 2999
Fax: (028) 9332 3232
