weber.teccable grout 

weber.tec cable grout is a low-modulus, semi-flexible polyester resin compound for filling cable slots. Can be used in asphalt, bitumen and concrete surfaces. Use for gaps 5 mm to 16 mm wide.

• Easy to mix and place
• Does not segregate or bleed
• Rapid setting for quick return to service
• Can be used in cold weather down to 0°C
• Good abrasion resistance
• Excellent chemical resistance

• Available in two colour grades: black for asphalt grey for concrete

• Available in 3 grades depending on application temperatures

All surfaces must be mechanically sound, dry and clean. All saw cuts should be free of slurry, dirt, dust, grease, oil or any other contaminants.

Saw cuts should be as narrow as possible, depending on cable size.

Surfaces should provide a textured, mechanical key for full bond.

The edges of slots should be cut sharp.

New concrete should be at least 7 days old prior to grouting.

Mix using a forced-action mixer, such as a Daines Mixal mixer or Cretengle, or using an EPi MR 130B helical paddle and slow speed drill (below 450 rpm).

Take care not to entrain air whilst mixing.

Part mixing

Part mixes may be made for smaller quantities using the cups provided.

Mix ratios by volume as follows:

• 1 plastic cup of resin
• 2 paper cups of hardener.

Mix in a clean mixing bucket, pour in the resin and then gradually stir in the powder hardener to achieve a smooth, even consistency.

Immediately after mixing, pour weber.tec cable grout into the prepared slot using a funnel or tun dish.

Top up as required within 2 hours.

weber.tec cable grout is not intended for filling large voids. For gaps wider than 15 mm, use weber.tec cable grout mixed with clean, dry, rounded aggregate up to 5 mm diameter. Up to 10 kg of aggregate can be used for gaps not exceeding 30 mm.

Setting times are dependent upon temperature. These are shown in the Technical Data table.

Clean tools with weber.tec solvent 3 before the grout sets.

Yield is 9·5 litres per pack.

Store in a cool, dry place out of direct sunlight. Shelf life in correct storage conditions is at least 12 months.

Protect from frost.

In hot weather conditions it is advisable to keep the product in refrigerated containers, transferred to insulated chambers/boxes on site.

Polyester-based.
Wear gloves when handling weber.tec cable grout.

When freshly mixed and before it has set, weber.tec cable grout is flammable, with a flash point of 30°C. The material can be handled safely and easily, provided that proper site cleanliness is observed. Operatives are advised to avoid direct contact by using barrier creams and protective clothing. In the event of contamination the product should be removed with soap and water or proprietary cleansing creams. Working areas should be well ventilated.

For further information, please request the Material Safety Data Sheet for this product.

weber's Customer Services Department has a team of experienced advisors available to provide on-site advice both at the specification stage and during application. Detailed specifications can be provided for specific projects or more general works. Site visits and on-site demonstrations can be arranged on request.

Technical helpline
Tel: (01525) 722110
Fax: (01525) 718988

weber products are distributed throughout the UK through selected stockists and distributors. For UK sales enquiries and overseas projects, contact weber's Sales office.

Sales office
Tel: (01525) 722100
Fax: (01525) 718988