weber.coteclear and smooth  

The weber.cote clear and smooth coating systems provide excellent anti-carbonation protection with a minimum 15 years life expectancy. weber.cote smooth is both protective and decorative, while weber.cote clear protects concrete surfaces without significantly altering their appearance.

All systems can be applied by brush, roller or spray .

These products have been formulated to comply with the requirements of BS EN 1504-2.

• Excellent anti-carbonation coatings.
• Durable - life expectancy in excess of 15 years.
• Resistant to chloride ion ingress.
• Coatings allow vapour diffusion.
• Agrément approved as part of the weber.cem Concrete Repair System.

weber.cote clear is a colourless coating.
weber.cote smooth coating is available in colours from the standard, premium and designer ranges. Specifiers should consult the Colour Charts, available from weber, and whenever possible, obtain samples prior to specification.

If considered necessary, substrates should be primed with weber.cote primer.

New surfaces should be clean, sound and dry. Concrete must be free of coatings or mould oil and any laitance should be removed following which the surface should be primed with weber.cote primer.

Old surfaces must also be clean, sound and dry. Glossy surfaces should be roughened to provide a key. Lichen, moss or fungal growth must be removed and the areas treated with weber CL150 applied in accordance with the instructions on the data sheet*.

Chalky or friable surfaces or previously decorated surfaces which are flaking should be wire brushed to remove loose materials and then stabilised by one coat of weber.cote primer.

On rough surfaces such as exposed aggregate panels, application of weber.cote clear is made easier if surfaces are primed with weber.cote primer, which should be allowed to dry before application of the first coat.

* Full data sheet available from weber on request.

For complete protection, a two coat application by brush, roller or spray is recommended.

Apply weber.cote smooth at a minimum of 150 µm wet film thickness per coat and weber.cote clear at a minimum of 100 µm wet film thickness per coat.

Depending on drying conditions and surface suction the weber.cote clear and weber.cote smooth coatings may be given a second coat in as little as 2 to 4 hours.
Do not apply below 4°C, when frost is expected or during rainfall.

EU limit for weber.cote clear (cat A/c):

75 g/l (2007)/40 g/l (2010). weber.cote clear contains <10 g/l VOC.

EU limit for weber.cote smooth (cat A/c):

75 g/l (2007)/40 g/l (2010). weber.cote smooth contains <35 g/l VOC.

Protect from frost. Store in clean, dry conditions between 5°C and 30°C. When stored in correct conditions a shelf life of 2 years can be expected.

Fire Properties

Essentially not hazardous.
Not harmful during normal use.
After contact with skin, wash immediately with plenty of water.
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
Keep out of the reach of children.

For further information, please request the Material Safety Data Sheet for this product.

weber 's Customer Services Department has a team of experienced advisors available to provide on-site advice both at the specification stage and during application. Detailed specifications can be provided for specific projects or more general works. Site visits and on-site demonstrations can be arranged on request.

Technical helpline
Tel: (01525) 722110
Fax: (01525) 718988

weber products are distributed throughout the UK through selected stockists and distributors. For UK sales enquiries and overseas projects, contact weber's Sales office.

Sales office
Tel: (01525) 722100
Fax: (01525) 718988